Mechanical Engineering

0 answers
Problem 3.28 in the textbook
Problem 3.28 in the textbook...
1 answers
Determine the forces acting on the members
The member ACF of the frame loaded as shown is connected to the member BCD by means of a smooth peg and slot arrangement. Determine all the forces acting on themembers BCD and ACF.(Ax = Fx = 3.04 kN, Ay = Fy = 2.7 kN; Bx = 6.08 kN; By = 1.8 kN; FC = 8.13 kN)Please show your work....
1 answers
Stress and Strain - Axial Loading
An 18-m long steel wire of 5-mm diameter is to be used in the manufacture of a prestressed concrete beam. It is observed that the wire stretches 45 mm when a tensileforce P is applied. Knowing that E = 200 GPa, determine the corresponding normal stress in the wire....
2 answers
Determining forces and components of force
In the frame shown, members ACE and BCD are connected by a pin at C, and by the link DE. Determine reaction force at A, the force in link DE for the loading shown, and components of force exerted at C on member BCD.(FDE = 561 N, Cy = 216 N; Cx = 795 N; Ay = 480 N; Ax = 300 N)....
0 answers
Thermo
Steam at 20 bars is in the saturated vapor state (call this state 1) and contained in a pistoncylinder device with a volume of 0.03 m 3 . Assume the steam is cooled atconstant volume (i.e. the piston is held fixed in place) until the temperature reaches 200 C (call this state 2). Then the steam is e...
0 answers
Calculate the vertical force P required to maintain equilibrium?
The oil drum weighs 620 lbwhen full and has a mass center atG. Calculate the vertical force Prequired to maintain equilibriumof the drum and dolly in theposition shown. The weight of thedolly may be neglected comparedwith that of the drum.Picture: http://tinypic.com/r/2po38fp/5...
0 answers
Thermodynamics question
A gas in a piston cylinder assembly undergoes a compression process for which the relation between pressure and volume is given by PV^n = constant. The initial volumeis 0.1 m^3, the final volume is 0.04 m^3, and the final pressure is 2 bar. Determine the initial pressure, in bar, and the work for th...
0 answers
Thermodynamics
Will rate instantly!Consider an insulated vessel shown below. The vessel has an evacuated compartment separated by a membrane from a second compartment that contains 1 kg of water at175oC, 1 MPa. The membrane then ruptures and the water fills the entire volume, with a resulting pressure of 15 kPa. D...
0 answers
Heat Transfer - Composite Wall
A composite wall of an oven consists of three materials. kA = 20 W/m-K, and kC = 50 W/m-K. LA = 0.30 m, LB = 0.15 m, and LC = 0.15 m. The outside surface temperatureof the oven is 20 C and the inside surface temperature is 613 C. The oven air temperature is 800 C, with a heat transfer coefficient h ...

Similar Solved Questions

1 answers
There different parts please solve all of them Required information The following information applies to the...
There different parts please solve all of them Required information The following information applies to the questions displayed below.) University Car Wash built a deluxe car wash across the street from campus. The new machines cost $267.000 including installation. The company estimates that t...
1 answers
How do you simplify #[(-2x y ^ { 2} ) ^ { 3} ] ^ { 2}#?
How do you simplify #[(-2x y ^ { 2} ) ^ { 3} ] ^ { 2}#?...
1 answers
A. A new operating system for an existing machine is expected to cost $290,000 and have...
a. A new operating system for an existing machine is expected to cost $290,000 and have a useful life of five years. The system yields an incremental after-tax income of $83,653 each year after deducting its straight-line depreciation. The predicted salvage value of the system is $11,000. b. A machi...
1 answers
A person is the arm out over a 32 bulding and throws a 200 gram brick...
A person is the arm out over a 32 bulding and throws a 200 gram brick straight upward, then put their arm in so that the brick doesn't eam when the brick falis back down. The speed of the brick is 29 ms the instant just before the brick touches the ground at the base of the building What is the ...
1 answers
Question 2 50 pts An object is placed at a distance f from a convex lens,...
Question 2 50 pts An object is placed at a distance f from a convex lens, wheref is the focal point. The size of the image is... Highly enlarged O Enlarged There is no image O Same size O Diminished...
1 answers
24. If the reaction quotient Qe is smaller than K., the reaction will proceed A) to...
24. If the reaction quotient Qe is smaller than K., the reaction will proceed A) to produce more product B) to produce more reactant C) nowhere D) to stoichiometric completion 25. The oxidation number (state) for iron (Fe) in FeCl2 is A)-1 B) +2 C) +3 D) -2 Page 4 26. In general, as temperature incr...
1 answers
4. You have a lung model whose airway flow is 90 liters/minute. The pressure at one...
4. You have a lung model whose airway flow is 90 liters/minute. The pressure at one end of the airway is 40 cm H2O, and the pressure at the other end of the airway is 5 cm H2O. What is the value for airway resistance in this model (watch your units!)?...
1 answers
What is an enzyme found in the mouth, stomach, and small intestine? What is the function of this enzyme?
What is an enzyme found in the mouth, stomach, and small intestine? What is the function of this enzyme?...
2 answers
What is 89 Fahrenheit in Celsius?
What is 89 Fahrenheit in Celsius?...
1 answers
Which mechanism is most likely for the reaction shown? (More than one choice may be possible)...
Which mechanism is most likely for the reaction shown? (More than one choice may be possible) SN2 BSN1 Radical Addition Br2 (1 equiv.) CsHg 1 h at 80 °C light Which mechanism is most likely for the reaction shown? (More than one choice may be possible) SN2 B SN1 Radical Addition NaCN DMF 50 °...
1 answers
Two long wires carrying 2.4-A current in opposite directions are 0.010m apart. What is the force...
Two long wires carrying 2.4-A current in opposite directions are 0.010m apart. What is the force per unit length of each wire? Is the force between the wires attractive or repulsive?...
1 answers
Determine the slope at point A and C and the deflection at point B in the...
Determine the slope at point A and C and the deflection at point B in the given beam. 15 K am 6...
1 answers
Determine the Rydberg constant for positronium (a bound system composed of a positron and an electron)...
Determine the Rydberg constant for positronium (a bound system composed of a positron and an electron) (a) Calculate the first three energy levels for positronium. (b) Find the wavelength of the H, line (3 + 2 transition) of positronium....
1 answers
Consider the diatomic molecule LiH. Calculate its anharmonicity constant assuming the values given for the fundamental...
Consider the diatomic molecule LiH. Calculate its anharmonicity constant assuming the values given for the fundamental ω¯0→1ω¯0→1 and first overtone ω¯0→2ω¯0→2 vibrational transitions. [ ω01=1.3588×103cm−1,ω02=2....
1 answers
Plz 7. Consider the following piston-cylinder arrangement which is thermally insulated. Initially, the same 1 mole...
plz 7. Consider the following piston-cylinder arrangement which is thermally insulated. Initially, the same 1 mole of ideal gas are confined in the cylinder A, B and C, respectively which are partitioned by a adiabatic piston and a diathermic piston as shown in Figure 1. The initial volume and abso...

-- 0.019010--