1

You are designing a new road for a two-lane highway. In order to intersect with an...

Question

You are designing a new road for a two-lane highway. In order to intersect with an...

You are designing a new road for a two-lane highway. In order to intersect with an existing road, the new road must meet the existing road at an elevation of 440.50 ft at station 192+ 56.00 Your new road has an initial tangent of +2.0% and a final tangent of-1.5%. The PVI is located at station 19150.00 and elevation 450.00 ft. Find the length of the curve necessary for this alignment. What is the maximum recommended design speed limit based on Caltrans design standards? 5.

You are designing a new road for a two-lane highway. In order to intersect with an existing road, the new road must meet the existing road at an elevation of 440.50 ft at station 192+ 56.00 Your new road has an initial tangent of +2.0% and a final tangent of-1.5%. The PVI is located at station 19150.00 and elevation 450.00 ft. Find the length of the curve necessary for this alignment. What is the maximum recommended design speed limit based on Caltrans design standards? 5.

Answers


Similar Solved Questions

1 answers
A curve passes through the point (0,6) and has the property that the slope of the...
A curve passes through the point (0,6) and has the property that the slope of the curve at every point P is three times the y-coordinate of P. What is the equation of the curve? Show your work in the PDF version of the test....
1 answers
A DC battery has a time to failure that is normally distributed with a mean of...
A DC battery has a time to failure that is normally distributed with a mean of 30 hours and a standard deviation of 4 hours. (a) What is the 25 hour reliability? (b) When should a battery be replaced to ensure that there is not more than a 5% change of failure prior to replacement? (c) Two batteries...
1 answers
LUATION METHODS ESTION 1 a) It is now January 1, 2014. Last year ABC Company experienced...
LUATION METHODS ESTION 1 a) It is now January 1, 2014. Last year ABC Company experienced major operational problems which affected the company's financial condition, forcing management to temporarily suspend dividend payments. It is expected that the company will not pay a dividend in 2014 and 2...
1 answers
Additional problems: Draw a mechanism for the following transformation. 1) Me MeNHNH2 HOAC Meo Meo OMe...
Additional problems: Draw a mechanism for the following transformation. 1) Me MeNHNH2 HOAC Meo Meo OMe Me- MeNHOH Meo Me OMe ОMe...
1 answers
Should a pregnant women be Punished for Exposing Her Fetus to Risk. please explain breifly and...
should a pregnant women be Punished for Exposing Her Fetus to Risk. please explain breifly and complete sentences....
1 answers
Term Answer Description Risk A. The risk of an asset when it is the only asset...
Term Answer Description Risk A. The risk of an asset when it is the only asset in an investor's portfolio. Expected rate of return That portion of an investment's risk calculated as the difference between its total risk and its firm-specific risk. Beta coefficient This model determines the a...
1 answers
Thermodynamic 2. A ste am power plant operates on an ideal regenerative Rankine cycle. Steam enters...
thermodynamic 2. A ste am power plant operates on an ideal regenerative Rankine cycle. Steam enters the turbine at 10 MPa and 500°C and is condensed in the condenser at 10 kPa. Steam is extracted from the turbine at 0.5 MPa to heat the feedwater in an open feedwater heater. Water leaves the f...
1 answers
In the figure (Figure 1) , each capacitance C1 is 5.7 ?F , and each capacitance...
In the figure (Figure 1) , each capacitance C1 is 5.7 ?F , and each capacitance C2 is 3.8 ?F...
1 answers
1. Discuss an ethical situation you have been faced with in the past. What did you...
1. Discuss an ethical situation you have been faced with in the past. What did you do? What could have done to adhere to higher ethical standards? Please make sure you provide a detailed example. 2. Do you think its ethical for a company to close a manufacturing facility in Canada and re-open it in ...
1 answers
6. (20 pts) Foran LTI system, when (t)=A(t)+6(t+1),n(t)-Au(-1- t); when (t)-26(t + 1) + δ(t)in(t) =...
6. (20 pts) Foran LTI system, when (t)=A(t)+6(t+1),n(t)-Au(-1- t); when (t)-26(t + 1) + δ(t)in(t) = e-Au(t-3). If the input is x3(t) = δ(t-1) + δ(t + 1), what is the output V3(t)?...
1 answers
Please help me please ! 1A.) Write a rate law from the image below. TRANSITION STATES...
please help me please ! 1A.) Write a rate law from the image below. TRANSITION STATES Ea(step 1) slow Ea(step 2) fast Potential energy NO2F+ F+NO2 2NO2+ F2 REACTANTS 1Hxn < 0 2NO2F PRODUCT Reaction progress A. Rate = k [NO2) B. Rate = k [NO2](F2] c. Rate = k [NO2)2[Fa] Address Group assignme...
1 answers
1. A study published in the New England Journal of Medicine in 1988 provided the prevalence...
1. A study published in the New England Journal of Medicine in 1988 provided the prevalence of myocardial infarctions in individuals taking aspirin vs. placebo. They found that of the individuals receiving placebo 189 out of 10,845 experienced MI. Of the 10,933 receiving aspirin 104 experienced MI. ...
1 answers
You are given the following for last year: The stock market index had a return of...
You are given the following for last year: The stock market index had a return of 10% with a standard deviation of return of 14%. An actively-managed portfolio (X) had a return of 16% with a standard deviation of 28%. The risk-free interest rate last year was 2%. What was the M-squared measure for p...
1 answers
Hypothesis calculation
An old scale displays a weight that is uniformly distributed between the real weight ±10 lbs. For example for a person with weight 110 lbs, the scale will show a weight uniformly distributed between 90 and 110.Consider the null hypothesis that a person weighs 100 lbs, and the alternative hypo...
1 answers
If 54.4 cm of copper wire (diameter = 0.869 mm, resistivity = 1.69 × 10-8Ω·m) is...
If 54.4 cm of copper wire (diameter = 0.869 mm, resistivity = 1.69 × 10-8Ω·m) is formed into a circular loop and placed perpendicular to a uniform magnetic field that is increasing at the constant rate of 9.52 mT/s, at what rate is thermal energy generated in the loop?...

-- 0.008142--